Post by account_disabled on Nov 16, 2017 6:40:24 GMT -5
Hello Guys,
Remove the switch, and either clip the wires or desolder them (I mark mine with sharpie so I know where they go when putting it back together). Then the part where the switch was held should just come out without any effort. Remove the screw, and the housing should come out (Careful with the arrows, they fall out, like mine). Now, twist the blade and push down (Of course, you should have removed the pommel and battery back). It should slide out pretty easily with minimal force. Just make sure you first twist the blade. Intro Videos can be a solid and sophisticated way to attract and connect with your target audience. Now, you need to punch out these two pins you need to pry open the casing. I went with a flat-head opening the seams. It's challenging, but take it slow. Don't underestimate this part, it truly is pretty difficult. As I said before, I broke off the power/speaker wires, and soldered them back from an image I found. Here's what I have wired correctly, along with the wiring for the LED conversion part
.
Thanks
Remove the switch, and either clip the wires or desolder them (I mark mine with sharpie so I know where they go when putting it back together). Then the part where the switch was held should just come out without any effort. Remove the screw, and the housing should come out (Careful with the arrows, they fall out, like mine). Now, twist the blade and push down (Of course, you should have removed the pommel and battery back). It should slide out pretty easily with minimal force. Just make sure you first twist the blade. Intro Videos can be a solid and sophisticated way to attract and connect with your target audience. Now, you need to punch out these two pins you need to pry open the casing. I went with a flat-head opening the seams. It's challenging, but take it slow. Don't underestimate this part, it truly is pretty difficult. As I said before, I broke off the power/speaker wires, and soldered them back from an image I found. Here's what I have wired correctly, along with the wiring for the LED conversion part
.
Thanks